Case Studies | Yamamoto Recycling Equipment

Upgraded from a 50 kg/h (110 lb/h) Unit to a Larger-Capacity Model as Processing Demand Increased

Application

Densification of EPS Foam (Appliance Packaging, etc.)

Industry: Waste Management

Product: Foam Densifiers

Model: RE-E2000/3000

Country: Japan


The company is a logistics provider that operates an intermediate waste processing and recycling facility at its own plant, primarily collecting waste from its business locations in Saitama Prefecture. A wide variety of materials are brought to the facility, including waste generated by home appliance retailers. Approximately 90 m3 (3,180 ft3), or 400-500 kg (880-1,100 lb), of waste is collected each day. Most of the appliance packaging is collected at home improvement centers.

For EPS densification, the company had been using YAMAMOTO’s all-in-one RE-E501 Foam Densifier with a processing capacity of 50 kg/h (110 lb/h). However, as the volume of EPS collected increased, the company began to face capacity limitations. To address this issue, the company decided to upgrade to the RE-E2000 / RE-E3000, which combines a shredding and storage system with a foam densifier capable of processing 200 kg/h (440 lb/h) - approximately four times the capacity of the previous machine

A company representative commented that the new system has significantly increased processing capacity and reduced the amount of EPS foam accumulating in the warehouse.

Collected EPS Foam

Palletized Densified Materials (Ingots)


Back to Case Studies


Page Top