Higher Capacity and Lighter Densified Material (Ingots) Cut Processing Time in Half
Application
Industry: Waste Management
Product: Foam Densifiers
Model: RE-E502/502X
Country: Japan

The company, an environmental cooperative serving a city and surrounding municipalities, receives EPS foam primarily from two sources: fish boxes collected from supermarkets and appliance packaging collected from electronics retailers. The collected EPS foam is densified using a foam densifier, reducing its volume to approximately 1/100 of the original, and is then shipped to a recycling facility.
The company had previously been using a foam densifier from another manufacturer but faced several challenges, including a long warm-up time and insufficient processing capacity. In addition, the densified materials (ingots) were heavy, placing a significant physical burden on its aging workforce.
To address these issues, the company decided to upgrade to YAMAMOTO’s RE-E502X Foam Densifier. The new machine reduces warm-up time to approximately 10 minutes and provides a processing capacity of 50 kg/h(110lb/h). In addition, each densified material (ingot) weighs about half as much as before. The machine was introduced with the expectation of reducing both processing time and the physical workload on operators.
When asked about the benefits of the new machine, a company representative said that work that previously took nearly a full day can now be completed in about half the time. The lighter densified materials (ingots) have also significantly reduced the physical burden on operators.
Another benefit is the machine’s ability to process a wider range of materials. While the previous machine was limited to EPS, the YAMAMOTO Foam Densifier can process additional compatible materials, which is expected to further improve the company’s recycling efficiency.


